Maintenance - Ryobi FPR3000 Operator's Manual

OPERATING THE PAINT SySTEM
See Figure 11, page 13.
Using the paint roller or pads:
 Install the roller or pads as described in the Assembly
section.
 Plug in the machine.
 Place the forward / reverse switch in the forward position
then turn the machine ON.
 Squeeze the trigger.
 Once the paint is flowing through the paint tube and into
the roller or pad, adjust the variable paint flow valve for
the desired paint coverage.
wARNING:
When servicing, use only identical Ryobi replacement
parts. Use of any other parts may create a hazard or
cause product damage.
wARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
fluids entering your eyes resulting in possible serious injury.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
wARNING:
Do not at any time let brake fluids, gasoline, penetrating
oils, etc., come in contact with plastic parts. Chemicals
can damage, weaken or destroy plastic which may result
in serious personal injury.
OPERATION
Using the finish sprayer:
 Install the finish sprayer as described in the Assembly
section.
 Plug in the machine.
 Place the forward / reverse switch in the forward position
then turn the machine ON.
 Aim the sprayer at the surface to be painted and squeeze
the trigger.
NOTE: Always test spray pattern on scrap material before
being to paint.
 Once the paint is flowing through the paint nozzle, adjust
the paint flow knob for the desired paint coverage.
NOTE: Turning the spray nozzle left or right will determine
the spray pattern.

MAINTENANCE

LUBRICATION
All of the bearings in this tool are lubricated with a sufficient
amount of high grade lubricant for the life of the unit under
normal operating conditions.
CAUTION:
It is important to thoroughly clean the sprayer after each
use or when changing colors. Allowing paint or stain to
remain in an idle tool for an extended period can cause
its moving pieces to seize up.
Do not clean with any flammable liquids such as paint
stripper, paint remover, brush cleaner, mineral spirits, lac-
quer thinner, turpentine, acetone, gasoline, kerosene, etc.
10 — English
wARNING: