Table of Contents
Advertisement
come in contact with the eyes, wash immediately with
clean water. If irritation persists, immediately seek
medical help.
■
Immediately turn off the product and remove the battery
pack in the event of accident or breakdown. Do not
operate the product again until it has been fully checked
by an authorised service centre.
■
Follow the safety instructions in this manual for mixing,
filling, application, emptying, cleaning, servicing and
transporting the product to avoid contamination of the
environment.
MIXING THE SOLUTION
■
Mix the chemicals strictly in accordance with the
manufacturer's instructions. Incorrect mixtures may
produce toxic fumes or explosive solutions.
■
Never use undiluted liquid plant control chemicals.
■
Prepare the solution and fill the container outdoors or in
well-ventilated areas only.
■
Prepare only sufficient solution for the job in hand so that
nothing is left over.
■
Do not mix different chemicals unless such mixture is
approved by the manufacturer.
FILLING THE CONTAINER
■
Make sure that the container is completely emptied and
cleaned before a different chemical is filled in.
■
Remove the battery pack before filling the container.
Wipe off any spills before installing the battery pack.
■
Stand the product on a level surface, and do not fill the
container above the maximum mark.
■
When filling from the tap, do not immerse the end of
the hose in the chemical solution. Sudden low pressure
in the system may cause the chemical solution to be
sucked back into the water supply.
■
Before filling the container with solution, carry out a test
run with fresh water, and check all parts of the product
for leaks.
■
Make sure that the filler cap is properly closed after
filling.
■
Hang a tag on the product to note what chemical solution
is being used.
APPLICATION
■
Never blow through nozzles or other components by
mouth.
■
Avoid contact with chemicals. Immediately change
clothing that are contaminated with chemicals.
■
Do not aim the nozzle towards persons, animals, and
electrical equipment.
■
Do not spray where spark, flame, or other source of
ignition is present.
■
Do not operate the product in windy conditions. Always
aim downwind.
■
Avoid using the product in freezing weather since the
solution may freeze.
■
To reduce the risk of accidents and damage to the
product, never operate the product with:
●
flammable liquids
●
viscous or sticky liquids
●
caustic or corrosive chemicals
●
liquids above room temperature
■
Clean the product after each use.
4
Original Instructions
■
Injuries may be caused, or aggravated, by prolonged
use of a tool. When using any tool for prolonged periods,
ensure to take regular breaks.
The product may be subject to national requirements for
regular inspection by designated bodies, as provided for in
Directive 2009/127/EC of the European Parliament and of
the Council of 21 October 2009 establishing a framework
for Community action to achieve the sustainable use of
pesticides.
ADDITIONAL BATTERY SAFETY WARNINGS
■
To reduce the risk of fire, personal injury, and product
damage due to a short circuit, never immerse your tool,
battery pack or charger in fluid or allow fluid to flow inside
them. Corrosive or conductive fluids, such as seawater,
certain industrial chemicals, and bleach or bleach-
containing products, etc., can cause a short circuit.
■
Charge the battery pack in a location where the ambient
temperature is between 10°C and 38°C.
■
Store the battery pack in a location where the ambient
temperature is between 0°C and 40°C.
MAINTENANCE
■
Use only original manufacturer's replacement parts,
accessories, and attachments. Failure to do so can cause
possible injury, can contribute to poor performance, and
may void your warranty.
■
Servicing requires extreme care and knowledge
and should be performed only by a qualified service
technician. Have the product serviced by an authorised
service centre only.
■
To avoid serious personal injury, always remove
the battery pack from the product when cleaning or
performing any maintenance.
■
After each use, check all parts of the product for leaks.
Return the product to an authorised service centre for
repair if necessary.
■
You may make adjustments or repairs that are described
in this manual. For other repairs, contact an authorised
service centre.
CLEANING THE REFILLABLE CONTAINER
■
Drain all chemical solutions from the refillable container
into a container approved for chemicals. Do not store the
chemicals in the refillable container.
■
Use clean water to clean and rinse the refillable
container. A small amount of mild household detergent
may be added. It may be necessary to rinse the refillable
container more than once.
CLEANING THE PRODUCT
■
Fill the tank about one-third full with clean water. A small
amount of mild household detergent may be added.
■
Do not use flammable solvents or abrasive cleaning
agents to clean the product.
■
Spray into a suitable container until the tank has been
emptied.
■
Refill and repeat the procedure with clean water. It may
be necessary to rinse the tank more than once, then
drain again as directed above.
■
Allow all parts to completely dry, then reinstall the tank
cap.
Advertisement
Table of Contents
