Using The Magnify Feature; Freezing The Screen - Hitachi CPS318W/CPX328W User Manual

USING THE MAGNIFY FEATURE

STANDBY/ON
VIDEO RGB SEARCH
ASPECT AUTO BLANK
MAGNIFY HOME PAGE UP VOLUME
ON
END PAGE DOWN MUTE
OFF
FREEZE KEYSTONE
POSITION MENU
ENTER
ESC RESET
NOTE
The projector will automatically exit from MAGNIFY mode if either the INPUT SELECT,
AUTO, ASPECT or VIDEO feature is used, or, if there is a change in the input signal's state.

FREEZING THE SCREEN

MAGNIFY HOME PAGE UP VOLUME
ON
END PAGE DOWN MUTE
OFF
FREEZE KEYSTONE
POSITION MENU
NOTE
• The projector will automatically exit from FREEZE mode if either the POSITION, VOLUME, MUTE, AUTO,
BLANK ON/OFF or MENU ON/OFF feature is used, or, if there is a change in the input signal's state.
• If the projector continues projecting the same image for a long time (i.e. you forget to exit FREEZE mode),
the image might possibly remain as an afterimage. Do not leave the projector in FREEZE mode for too long.
Press the MAGNIFY (ON) button
1
The projector enters MAGNIFY mode.
Press the POSITION button, then use the
2
,
buttons to select the area to enlarge and then
press the POSITION button again to confirm your
selection
POSITION
Press the
3
out of the selected area.
Press the MAGNIFY (OFF) button to exit MAGNIFY mode
and restore the screen to normal. (The projector will also
automatically exit MAGNIFY mode if there is a change in the
input signal's state.)
Press the FREEZE button
1
The [II] icon appears and the screen will freeze at
the current image. Press the FREEZE button again
and the [ ] appears as the projector exits FREEZE
mode.
,
buttons to zoom in and
MAGNIFY MAGNIFY
ON
, ,
POSITION
FREEZE
21