Table of Contents
Advertisement
Option Switches (DIP Switch)
16
Part 2. Preparation
Remove the two slotted screws by using a slotted screwdriver. Remove the
access cover to change the DIP switch settings. (Refer to the following
figure for details changing the DIP switch settings.)
After changing the DIP switch settings, replace access cover and tighten the
two slotted screws using a slotted screwdriver.
CAUTION
Before removing the access cover to change DIP switch settings on the
drive, turn off the computer and disconnect the power cord from the unit.
Once the DIP switch settings have been changed, replace the access cover
using the two original slotted screws provided.
DIP Switch Positions
Default (AITe260, AITe130, AITe90)
ON
OFF
1
2
3
4
Default (AITe520, AITe390)
ON
OFF
1
2
3
4
DIP Switch
5
6
7
8
1
2
3
4
5
6
7
8
5
6
7
8
Access Cover
Slotted
Screws
1
Drive Mode (OFF)
2
Drive Mode (OFF)
3
Drive Mode (OFF)
4
Drive Mode (OFF)
5
Terminator Power (ON)
6
Periodic Cleaning Req (OFF)
7
DC Control (1) (ON)
8
DC Control (2) (OFF)
DR (Disaster Recovery) Mode
(OFF)
Emulation Mode (OFF)
AIT Library Interface Mode (ON)
Reserved (OFF)
Terminator Power (ON)
Periodic Cleaning Req (OFF)
DC Control (1) (ON)
DC Control (2) (OFF)
Advertisement
Table of Contents
