Installation - Zanussi ZHP6022 User Manual

INSTALLATION

Drilling the Support surface and Fitting the hood
• The Hood can be fitted directly on the lower surface
of the Wall Units (650 mm min. above the Cooker
Top) using the snap-on Side Supports.
• Make an opening on the lower surface of the Wall
Unit, as indicated. (fig.1)
• Choose the correct flange measure basing on the air
outlet diameter and insert it to the upper air outlet
opening. (fig.2)
• Screw the closing profile 20 onto the rear part of
the hood, using the screws 12f (2.9 x 9.5) provided.
(fig.3)
• Open the sliding suction panel.
• Remove the metal grease filters one by one after ha-
ving disconnected the relative fas-tening elements.
• Close the sliding suction panel again.
• Insert the Hood until the snap-on side sup-ports click
into place. (fig.4)
• Open the sliding suction panel.
• Lock in position by tightening the screws Vf from
underneath the Hood. (fig.4)
• If necessary, adjust the whole filter holder unit and
proceed as follows:
• Loosen the four adjustment screws Vr and close the
sliding panel again. (fig.5)
• Move the entire filter holder unit until it is properly
aligned with the wall unit. (fig.6)
• Keeping the hood canopy still, remove the sliding
panel and lock the adjustment screws again. (fig.5)
• The hood can now be fastened to the wall unit using
the four screws 12a (3.5 x 16) provided. (fig.7)
• Replace the metal grease filters.
• Close the sliding suction panel again.
GB
�
���
���
�
�
�
���
�
�
�
6