Introduction
The DRU-120A offers the following
Reads CD-ROM discs at up to 32×
features.
speed.
Features “Power-Burn conformed”
An internal DVD+RW/CD-RW drive
technology to prevent buffer under-run
with ATAPI (EIDE) interface for PCs.
errors.
Writes up to 2.4× speed on DVD+R/
“Power-Burn conformed” is used to refer
DVD+RW disc media.
to a CD-R/RW that uses CD-R/RW
Reads DVD-ROM/DVD+R/DVD+RW
recording technology (ICs and/or
discs at up to 8× speed.
firmware) other than Power-Burn, but
Writes up to 12× speed on CD-R disc
provides performance equivalent to that
media.
of Sony original Power-Burn technology
Writes up to 10× speed on CD-RW disc
based on the Power-Burn concept.
media.
System Requirements
The DRU-120A can be used in systems with
One empty 5-inch half-height drive bay
the following capabilities.
One available internal +12 V/+5 V power
connector
CPU: Pentium II 400 MHz or higher
recommended.
CAUTION
PC/AT-compatible PC
• The above system requirements is given as a
OS:
minimum requirement for a system on which basic
Windows 98 Second Edition
writing performance can be obtained. In actual use,
(Windows 98 SE),
the requirements for the writing software and other
Windows 2000 Professional
supplied software also have to be taken into
consideration. (Normally, these requirements will be
(Windows 2000),
higher than the above specifications.) Refer to your
Windows Milienium Edition
software user’s guides for details.
(Windows Me),
• The drive cannot be assured to operate properly if
Windows XP Home Edition or
connected to an ATAPI interface adapter card (we
cannot guarantee compatibility or offer user support).
Windows XP Professional
• Writing speed may automatically be adjusted
(Windows XP)
depending on the disc specified speed or disc
At least 64 MB RAM
conditions such as weight imbalance and eccentricity.
At least 1 GB available hard disk space
One available EIDE(ATAPI) interface
connection (primary slave, or secondary
master or slave)
Accessory List
Please verify that the package includes the following accessories with the DRU-120A when
unpacking.
If any of these items appears to be missing or damaged, please contact your supplier.
• DRU-120A drive
• Screws (×4)
• DRU-120A User’s Guide
• Quick Start Guide
• Software Quick Start Guide
• Blank DVD+RW disc
• Software Disc
• Warranty Card
Note
To guard against possible loss or damage, be sure to make a backup copy of the provided software disc on a CD-R
disc or other media. The software disc is not sold separately.
Please Record Responsibly
Before copying anything onto a disc, please be sure you are not violating copyright laws.
Most software companies allow you to make a back-up or archive copy of software. Check
your software’s license agreement for specific details.