Yamaha WaveRunner XL800 2001 Owner's/Operator's Manual page 30

1 Engine shut-off cord (lanyard)
Attach to wrist so that the engine stops if the
operator falls off the watercraft.
2 Engine stop switch
Push to stop the engine normally.
3 Clip
Insert into the engine shut-off switch to enable
starting of the engine.
Remove to stop the engine or prevent acci-
dental starting of the engine or unauthorized
use of the watercraft.
4 Quick Shift Trim System (QSTS) selector
Use to select the trim angle of the watercraft.
5 QSTS shift lock lever
6 Engine shut-off switch
Remove the clip to stop the engine and dis-
able it from starting.
7 Start switch
Push to start the engine.
8 Adjustable rearview mirrors
9 Multifunction meter
Use to check watercraft operation.
0 Shift lever
Use to put the watercraft into forward or
reverse.
A Throttle lever
Use to accelerate and decelerate.
B Tilt lever
Use to adjust the tilt of the handlebars.
C Reverse gate
Controls direction of jet thrust when in reverse.
D Stern drain plugs
Use to drain water in the bilge when the water-
craft is on dry land.
E Jet thrust nozzle
Changes the direction of jet thrust according
to handlebar position.
F Ride plate
2-3
E