Air Filter - Hitachi CP-X600 Operating Manual

Maintenance

Air filter

Please check and clean the air filter periodically. If the air filter becomes clogged
by dust or the like, internal temperatures rise, which could cause a fire, a burn or
malfunction to the projector. When the indicators or a message prompts you to
clean the air filter, comply with it as soon as possible. Note that the projector may
shut down, when the projector heats too much.
Please replace the air filter when it is damaged or too soiled. Preparation of a new
air filter is recommended. To prepare a new air filter, contact with your dealer and
tell the air filter type number.
Type number = MU03642
Cleaning the air filter
.
Turn the projector off, and unplug the
power cord. Allow the projector to
sufficiently cool down.
.
Use a vacuum cleaner on and around the
filter cover.
3.
Hold the filter cover knobs while lifting it.
The filter unit made up the filter cover and
others will come off.
4.
Use a vacuum cleaner for the filter vent of
the projector and the filter frame side of
the filter unit.
If the air filter is damaged or too soiled,
replace it according to the following
procedure number 5 to 7. Otherwise, please
jump to the procedure number 8.
5.
To remove the filter frame, hold the filter
cover while holding and pulling the filter
frame's knob by another hand.
6.
Replace the air filter with new one. It is
recommended that the fluted surface of
the air filter faces the filter cover.
7.
Put the filter frame back.
8.
Put the filter unit back into the projector.
(continued on next page)
54
The front side of the projector
The filter cover knobs
The filter unit
The filter frame knob
The filter frame
The air filter
The filter cover
The filter cover
The fluted
surface of
the air filter