Watchguard Firebox X55e Quick Start Manual page 3

TCP/IP Settings
IP Address
Subnet Mask
Default Gateway
To find your TCP/IP settings if you use a non-Windows operating system, see Chapter 2 of the User Guide.
3
Before You Connect to the Firebox
1. To connect to the Firebox X Edge, you must configure your computer to use DHCP.
information, see "Setting Your Computer to Connect to the Edge" in Chapter 2 of the User Guide.)
2. Make sure the proxy server setting is disabled in your web browser. You cannot connect
to the Firebox X Edge if you use a proxy server.
Settings" in Chapter 2 of the User Guide.)
3. Make sure that your web browser is not set to block pop-up windows. You cannot start the
Quick Setup Wizard if you block pop-up windows.
Blocking Settings" in Chapter 2 of the User Guide.)
4
Connect the Firebox
1. Turn off your computer and DSL/cable modem.
2. Disconnect the Ethernet cable attached to your DSL/cable modem, and connect it to
the"WAN 1" interface on the Firebox X Edge.
3. Connect one end of the green Ethernet cable supplied with your Edge to one of the three
Ethernet interfaces (labeled LAN0-LAN2) on the Edge. Connect the other end to the
Ethernet interface of your computer.
4. Turn on your DSL/cable modem.
(
When the indicator lights of the modem stop flashing, the modem is ready for use.)
.
5
Make sure the plug on the AC adapter matches the power source used in your country. If it
does not match, use your thumb or finger to move the locking key on the power adapter
down. Pull up from the bottom of the plug to remove it. To insert the correct plug:
6. Attach the AC adapter to the Edge and connect the adapter to a power source. Wait for 30
seconds, then turn on your computer.
(
If you get a message that says your operating system has no network connection, repeat steps 1-5.)
Primary DNS
Secondary DNS
DNS Domain Name Suffix
X Edge to Your Computer
®
Put the top of the new
plug into the AC adapter
at a 45-degree angle.
PPPoE Settings
Name
Domain
Password
X Edge
®
(
For more information, see "Web Browser HTTP Proxy
(
For more information, see "Web Browser Pop-Up
Push the bottom of the plug
into the AC adapter until the
plug clicks into position.
Photo by GlobTek®
(
For more