Westerbeke 8.0KW-60HZ Operator's Manual page 19

SCHEDULED
MAINTENANCE
Heat Exchanger
Raw Water Pump
Coolant System
* Starter Motor
Distributor
*Engine Cylinder
Compression and
Valve Clearance
*Exhaust Elbow
MAINTENANCE SCHEDULE
NOTE:
Use the engine hourmeter gauge to log your engine hours or record your
engine hours by running time.
CHECK
HOURS OF OPERATION
EACH
EXPLANATION OF SCHEDULED
DAY 50 100 250 500 750 1000 1250 MAINTENANCE
0 0 0 0 0 0 0 Clean or replace anode. Open heat exchanger end
cap and clean out debris. Remove every 1000 hours
for professional cleaning and pressure testing.
0 0 0 Remove pump cover and inspect impeller for wear;
replace if needed. Also replace gasket. Lubricate
both wilen reassembling.
0 Drain, flush, and refill cooling system with
appropriate antifreeze mix.
0 0 Cileck solenoid and motor for corrosion. Remove
and lubricate. Clean and lubricate the start motor
pinion drive.
0 0
Check ignition timing. Check condition of
distributor cap and rotor.
0 0
Incorrect valve clearance will result in poor engine
performance; check compression pressure and timing,
and adjust valve clearances.
0 Test exhaust elbow for casting integrity. Replace if
casting is corroded or deteriorated.
WARNING: A defective exhaust elbow can cause
carbon monoxide leakage!
Carburetor Fuel Filter Screen 0 0 0 0 0
Test exhaust elbow for casting integrity. Replace if
casting is corroded or deteriorated.
WARNING: A defective exhaust elbow can cause
carbon monoxide leakage!
*Engine Timing Belt
at 3000 Operating Hours Remove and replace.
*WESTERBEKE recommends this service be performed by an authorized mechanic.
Engines & Generators
13