Table of Contents
Advertisement
ASSEMBLY
e
Fuel pump
• Make sure that the marks "2" and "0" on the
driven pulley and the mark"
\1"
on the cylinder
head are aligned in a straight line.
• Apply the engine oil for the 4-stroke cycle engine
to the top of the plunger and O-ring of the fuel
· pump.
Crank shaft holder
Tightening torque: 5-6 N - m (0.5-0.6 kg - m)
(3.6-4.3 Ib - ft)
e
Drive pulley
• For tightening the nut to· fasten the drive pulley,
use the crank shaft holder.
Tightening torque: 34-36 N-m (3.4-3.6 kg-m)
(25-26 Ib - ft)
Crank shaft
lock
washer
(Bend it by a part.)
Plate
Drive pulley
• After tightening the nut, bend up the lock washer
by a part.
e
Oil filter
• Apply the engine oil for the 4-stroke cycle engine
to the rubber seal of the oil filter.
FILTER WRENCH
OIL FILTER
Tightening torque: 18 N - m (1.8 kg - m)
(131b - ft)
• Water Injected Exhaust
Elbow
~
<:b,
.
,
,
,
I,~,~)
~
•
PULLEY BOLT
!
25-30Nm
~
OIL PAN
• Oil Pan
Coat the new gasket with
three bond #12078 on both sides
and mount the oil pan. TIghten
the cap screws gradually in
opposing order.
Torque at 28 - 30 Nm (20 - 22 Ib-ft)
~
WESTERBEKE
Engines
&
Generators
31
Advertisement
Table of Contents
