Advertisement
U S E R ' S G U I D E
Thank you and congratulations for choosing the H2O Mop. The H2O Mop is a new way of cleaning that is
effective and far more hygienic than conventional methods. The H2O Mop achieves a high degree of hygienic and
increasing cleansing power by converting water into steam using a microfiber floor cloth enhancing absorbency.
When contact is made with floor surfaces, dirt and grime can be eliminated in a matter of seconds. Since the
H2O Mop uses the active power of steam without the use of detergents or soap, it is environmentally friendly.
When used correctly the H2O Mop can kill dust mites and some types of bacteria. To disinfect a specific area,
position the steamer over the area for a minimum of eight seconds. The steam temperature will reach to
approximately 90-100°C (194-212°F). Use this procedure to disinfect floors in bathrooms, showers, around
kitchen counters, pet sleeping quarters, etc.
INSTRUCTIONS FOR USE
The H2O Mop is designed to thoroughly clean floor surfaces, such as marble, ceramic, stone, linoleum, sealed
h a rdwood floors and parquet.
WA R N I N G : On surfaces that have been treated with wax, the wax may be removed by the heat and steam action.
Do not use on unsealed wood floors or let unit stand on any wood floor for an extended period of time. This could
cause the wood grain to rise. When using on vinyl, linoleum or any other heat sensitive floors, use extra caution.
Too much heat can melt down glue in the flooring. It is there f o re recommended that a sample cleansing be carr i e d
out on an isolated area of the floor. It is also recommended that you check the use and care instructions of the
s u rface from the floor manufacturer to ensure suitability to steam cleaning.
H20 Mop uses tap water. Residents in areas with hard water, should use distilled water for better perf o rm a n c e .
HOW TO ASSEMBLE AND USE
1 ) Attach head to body.
2 ) S e c u re head with the small Philips Head Screw until it is fully tightened.
3
U S E R ' S G U I D E
3 ) Make sure that the Handle Ring is properly positioned onto the designated hole in the main body before
attaching the handle. Note: the Handle ring comes preinstalled on the body.
4 ) I n s e rt the Handle down into the body and verify that the Handle ring is firmly sited around the Handle.
5 ) S c rew the Large Philips Head screw through the opening at the back of the body into the rear of the handle,
tighten with screwdriver until secure .
6 ) Place the Microfiber Cloth Pad or disposable pad (optional item) onto the mop head.
Note: Microfiber Cloth is washable while the disposable pad (optional item) is intended for one-time use.
7) Fasten the Microfiber Cloth Pad by pulling the cord while pressing on Toggle. Note: this step is not re q u i red if
you are using disposable pad (optional item). Disposable pad comes with built in elastic cord .
8) When using H2O Mop on carpets, place the mop head (with microfiber cloth or disposable pad in place) over the
Carpet Glider.
NOTE: Do not operate without either Microfiber Cloth or disposable pad (optional item) in place.
4
Advertisement
