Radio Frequency (Rf) Energy - Zte 4G Mobile Hotspot User Manual

—Consult the dealer or an experienced radio/ TV technician for help.

Radio Frequency (RF) Energy

This 4G Mobile Hotspot meets the government's requirements for exposure to radio waves.
This 4G Mobile Hotspot is designed and manufactured not to exceed the emission limits for exposure to
radio frequency (RF) energy set by the Federal Communications Commission of the U.S. Government:
The exposure standard for wireless devices employs a unit of measurement known as the Specific
Absorption Rate, or SAR. The SAR limit set by the FCC is 1.6W/kg. *Tests for SAR are conducted
using standard operating positions accepted by the FCC with the device transmitting at its highest certified
power level in all tested frequency bands. Although the SAR is determined at the highest certified power
level, the actual SAR level of the 4G Mobile Hotspot while operating can be well below the maximum
value. This is because the 4G Mobile Hotspot is designed to operate at multiple power levels so as to
use only the poser required to reach the network. In general, the closer you are to a wireless base station
antenna, the lower the power output.
The highest SAR value for the 4G Mobile Hotspot as reported to the FCC when worn on the body, as
described in this user guide, is 1.080 W/kg (Body-worn measurements differ among device models,
depending upon available enhancements and FCC requirements.)
While there may be differences between the SAR levels of various devices and at various positions, they
all meet the government requirement.
The FCC has granted an Equipment Authorization for this 4G Mobile Hotspot with all reported SAR
levels evaluated as in compliance with the FCC RF exposure guidelines. SAR information on this 4G
Mobile Hotspot is on file with the FCC and can be found under the Display Grant section of
http://www.fcc.gov/oet/fccid after searching on FCC ID: Q78-ZTEMF61
Confidential and Proprietary Information of ZTE CORPORATION 55