Connecting The Power Supply; Adjusting The Projector's Elevator - Hitachi CP-X1200 Quick Manual

Connecting The Power Supply

Connecting The Power Supply
WARNING • Use extra caution when connecting the power cord as incorrect or faulty
connections may result in fire and/or electrical shock. Please adhere to the "User's manual –
Safety Guide" and the following.
• Only plug the power cord into outlets rated for use with the power cord's specified voltage range.
• Only use the power cord that came with the projector. If it is damaged, contact your dealer to
newly get correct one.
• Never modify the power cord. Never attempt to defeat the ground connection of the three-pronged plug.
• Make sure that you firmly connect the power cord to the projector and wall outlet.
Connect the connector of the power cord to
1
the AC inlet of the projector.
Firmly plug the power cord's plug into the
2
outlet.

Adjusting The Projector's Elevator

Adjusting The Projector's Elevator
WARNING • Do not touch about the lens and ventilation openings during use or
immediately after use to prevent a burn.
CAUTION • To prevent damaging the projector and injuring yourself, always
hold the projector whenever using the elevator buttons to adjust the elevator feet.
Press and hold in the elevator buttons.
1
Raise or lower the projector to the desired height and
2
then release the elevator buttons.
When you release the elevator buttons, the elevator
feet will lock into position.
As necessary, you can also finely adjust the height of
3
the projector by twisting the elevator feet by hand.
4
AC Inlet
Connector
Elevator buttons
Elevator feet
Outlet
Plug