Preparing Remote Control - Hitachi CP-X1200 Quick Manual

Preparing Remote Control

Preparing Remote Control
WARNING • The laser pointer of the remote control is used in place of a finger or
rod. Never look directly into the laser beam outlet or point the laser beam at other
people. The laser beam can cause vision problems.
CAUTION • Use of controls or adjustments or performance of procedures other
than those specified herein may result in hazardous radiation exposure.
AVOID EXPOSURE-LASER
RADIATION IS EMITTED
FROM THIS APERTURE
C A U T I O N
LASER RADIATION
DO NOT STARE INTO BEAM
WAVE LENGTH: 640-660nm
MAX OUTPUT: 1mW
CLASS 2 LASER PRODUCT
Comples with 21 CFR, 1040.10 AND 1040.11
IEO60825-1:1993+A1:1997+A2:2001
LASER-STRAHLING
NICHT IN DEN STRAHL BLICKEN
LASER KLASSE 2
WAVE LENGTH:640-660nm MAX OUTPUT:1mW
レーザー光
ビームをのぞきこまないこと
クラス2レーザー製品 JIS C 6802 （1998）
最大出力：1.0mW 波長：640−660nm
MODEL:H-IRC4
MANUFACTURER:
MANUFACTURED
JANUARY,2003
INTERLINK K.K.
1-10-7 HIGASHIKANDA CHIYODA-KU,TOKYO,JAPAN
101-0031
MADE IN CHINA
CAUTION • About the battery
• Keep a battery away from children and pets.
• Use only the battery specified: two AA batteries.
• Do not mix new battery with used one.
• Make sure the plus and minus terminals are correctly aligned when loading the
battery (as indicated in the remote control).
• Dispose of batteries in accord with environmental laws.
Remove the battery cover.
1
Slide back and remove the battery cover in the direction of
the arrow.
Insert the batteries.
2
Align and insert the two AA batteries according to their plus
minus terminals (as indicated in the remote control).
Close the battery cover.
3
Replace the battery cover in the direction of the arrow and
snap it back into place.
B
レーザー光をのぞき込まないこと。
レーザー光を人に向けないこと。
子供に使わせないこと。
製造者：INTERLINK ELECTRONICS
P S
JQA
MADE IN CHINA
C
5