Adjusting The Projector's Elevator; Using The Lens Shift Buttons - Hitachi CP-X1200 User Manual

Setting Up (continued)
Setting Up (continued)

Adjusting The Projector's Elevator

WARNING • Do not touch about the lens and ventilation openings during use or
immediately after use to prevent a burn.
CAUTION • To prevent damaging the projector and injuring yourself, always
hold the projector whenever using the elevator buttons to adjust the elevator feet.
You can use the elevator feet to make adjustments if the surface on which you need to set
the projector is uneven or if you otherwise need to adjust the angle of projection. The
adjustment range of the elevator feet is 0 to 9 degrees.
Press and hold in the elevator buttons.
1
Raise or lower the projector to the desired height and
2
then release the elevator buttons.
When you release the elevator buttons, the elevator
feet will lock into position.
As necessary, you can also finely adjust the height of
3
the projector by twisting the elevator feet by hand.

Using The Lens Shift Buttons

NOTE
• Generally, better quality of a picture is available when the lens shift is set
to the center.
The lens of this projector can be shifted
vertically. When you want to finely adjust the
picture position, use the LENS SHIFT buttons
of the projector.
LENS SHIFT
LENS SHIFT buttons
Projector
LASER INDICATOR
STANDBY/ON VIDEO RGB
+ + +
LENS SHIFT FOCUS ZOOM
– – –
BLANK ASPECT LASER
Remote control
Elevator buttons
Elevator feet
10:0
1:1
7