Adjusting The Projector's Elevator - Hitachi CPX7 User Manual

Adjusting the projector's elevator

When the place to put the projector is slightly uneven to
the left or right, use the elevator feet to place the projector
horizontally.
Using the feet can also tilt the projector in order to project
at a suitable angle to the screen, elevating the front side of the projector within
degrees.
This projector has 2 elevator feet and 2 elevator knobs. An elevator foot is
adjustable while pulling up the elevator knob on the same side as it.
1. Holding the projector, pull the elevator knobs up to loose the elevator feet.
Position the front side of the projector to the desired height.
2.
Release the elevator knobs in order to lock the elevator feet.
3.
After making sure that the elevator feet are locked, put the projector down
4.
gently.
If necessary, the elevator feet can be manually twisted to make more precise
5.
adjustments. Hold the projector when twisting the feet.
1
To loose an elevator foot, pull up the
elevator knob on the same side as it.
CAUTION ►Do not handle the elevator buttons without holding the
projector, since the projector may drop down.
►Do not tilt the projector other than elevating its front within 12 degrees using
the adjuster feet. A tilt of the projector exceeding the restriction could cause
malfunction or shortening the lifetime of consumables, or the projector itself.
NOTE • The projector may make a rattling sound when tilted, moved or
shaken, since a flap to control the air flow inside of the projector has moved. Be
aware that this is not a failure or malfunction.
10
5
To finely adjust, twist the foot.
12°
12