Removing The System Feet; Installing The System Feet; Wheel Assembly (Optional)-Tower Mode - Dell PowerEdge T420 Owner's Manual

Removing The System Feet

NOTE: It is recommended that you remove the system feet only when you are converting the system from the tower
mode to the rack mode, or when you are replacing the system feet with the wheel assembly.
1. Rotate the system feet inward.
2. Lay the system on its side on a flat, stable surface.
3. Remove the screws securing the system feet to the base of the tower.
Figure 12. Removing and Installing the System Feet
1. base of the tower
2. system feet (4)
3. screws (4)

Installing The System Feet

1. Lay the system on its side on a flat, stable surface.
2. Secure the system feet to the base of the tower using the screws.
3. Place the system upright on a flat, stable surface and turn the system feet outward.
Wheel Assembly (Optional)—Tower Mode
The wheel assembly provides mobility to the system in the tower mode.
The wheel assembly consists of the following:
43