Types Of Isolate Fx Effects - Pioneer Remix station RMX-1000 Operating Instructions Manual

SCENE FX control Sets the cutoff frequency of the low pass filter.
SUB PARAMETER 1
Sets the echo sound's delay time.
control
SUB PARAMETER 2
Applies a modulation effect to the output.
control
CRUSH ECHO
This function creates a sound as if the input sound were crushed and
passes it through the filter and echo before outputting it.
The echo is output several times according to the multiplying factor of
the input sound's beat, with the delay sound gradually attenuating.
Cycle
SCENE FX
control
SCENE FX control Sets the degree by which the input sound is crushed.
SUB PARAMETER 1
Sets the echo sound's delay time.
control
SUB PARAMETER 2
Applies a modulation effect to the output.
control
SPIRAL DOWN
This function adds a reverberation effect to the input sound.
When the delay time is changed, the pitch changes simultaneously.
Input sound turned off
1 beat
SCENE FX control Sets the SPIRAL's delay time.
SUB PARAMETER 1
Sets the echo sound's delay time.
control
SUB PARAMETER 2 Sets the amount of pitch shifting by which the pitch is
control decreased.
REVERB DOWN
This function adds a reverberation effect to the input sound.
Direct sound
Early reflected sound
Level
Reverberations
SCENE FX control Use this to set the degree of the reverb effect.
SUB PARAMETER 1
Use this to set the degree of the reverb effect.
control
SUB PARAMETER 2
Sets the cutoff frequency of the low pass filter.
control
Frequency
Time
Fade-out
Time
Time

Types of ISOLATE FX effects

ISOLATOR
This function allows you to split the input sound into three bands – low,
mid, and high – and adjust the audio level for the respective bands.
LOW control Adjusts the audio level of the low frequencies.
MID control Adjusts the audio level of the mid frequencies.
HI control Adjusts the audio level of the high frequencies.
CUT/ADD
 CUT: When turned counterclockwise
This function allows you to adjust the audio level of the bass drum
detected in the input sound and the manual filter's cutoff frequency.
Adjusts the audio level of the bass drum detected in the
LOW control
input sound.
Applies the sound other than the bass drum detected in
MID control
the input sound to the high pass filter.
Applies the sound other than the bass drum detected in
HI control
the input sound to the low pass filter.
Bass drum
Bass drum
Bass drum
Bass drum
Bass drum
Bass drum
 ADD: When turned clockwise
This function lets you apply a 1/8-beat delay sound according to the
multiplying factor of the input sound's beat.
LOW control Adjusts the audio level of the low frequency delay sound.
MID control Adjusts the audio level of the mid frequency delay sound.
Adjusts the audio level of the high frequency delay
HI control
sound.
1/1 beat
1/2 beat
1/4 beat
1/8 beat
Frequency
Time
17
En