First Time Use - Hitachi GX Series 43GX01B Operating Manual

POWER light
You will see a red light when the TV is turned on.
AI (Artificial Intelligence) sensor
The artificial Intelligence sensor will make automatic picture adjustments depending on the amount of light in the
room to give the best picture. (See page 48.)
REMOTE CONTROL Sensor
Point your remote control at this area when selecting channels, adjusting volume, etc.
DIGITAL ARRAY
Use this button to enter Digital Array mode. This will allow you to adjust your picture quality to optimum
performance. (See page 37.)

FIRST TIME USE

Antenna Input/Output
The remote control allows you to switch between two separate 75-Ohm RF antenna inputs, ANT A and ANT B.
ANT A input can be displayed as a main picture or sub-picture. ANT B can only be displayed as a main picture.
(ANT B cannot be displayed as a sub-picture.) The antenna output labeled "TO CONVERTER" allows the ANT A
connection to pass directly to a different source such as a cable box, when ANT B is displayed as a main picture.
Audio/Video Inputs 1and 2
The INPUT button will step through each video source and antenna source input each time it is pressed. Use the
audio and video inputs to connect external devices, such as VCRs, camcorders, laserdisc players, DVD players,
etc. (If you have mono sound, insert the audio cable into the left audio jack).
NOTE: You may use VIDEO, S-VIDEO, or COMPONENT VIDEO: Y-CB-CR inputs to connect to INPUT 2, but
note that only one of these may be used at a time.
Monitor Out
These jacks provide fixed audio and video signals which are used for recording. To have S-VIDEO output, S-
VIDEO signal needs to be input to INPUT 1 or INPUT 2.
(4) AUDIO TO HI-FI
These jacks provide variable audio output to a separate stereo amplifier. With this connection, the audio to the
stereo can be controlled by the television's main volume.
(5) S-VIDEO INPUTS 1 and 2
Inputs 1 and 2 provide S-Video (Super Video) jacks for connecting equipment with S-Video output capability.
(6) Component Video: Y-CB-CR INPUT 2