First Time Use - Hitachi 50GX49B Operating Manual

FIRST TIME USE
(_ Antenna Input/Output
The remote control allows you to switch between two separate 75-Ohm RF antenna inputs, ANT A and ANT B. ANT A input can
be displayed as a main picture or sub-picture. ANT B can only be displayed as a main picture. (ANT B cannot be displayed as a
sub-picture.) The antenna output labeled =TO CONVERTER" allows the ANT A connection to pass directly to a different source
such as a cable box, when ANT B is displayed as a main picture.
(_) Audio/Video Inputs 1, 2
The INPUT button will step through each video source and antenna source input each time it is pressed. Use the audio and video
inputs to connect external devices, such as VCRs, camcorders, laserdisc players, DVD players etc. (If you have mono sound, insert
the audio cable into the left channel jack.)
NOTE: You may use VIDEO, S-VIDEO, or COMPONENT: Y-CBC R inputs to connect to Input 2, but note that only one of these I
may be used at a time.
I
(_ Monitor Out
These jacks provide fixed audio and video signals which are used for recording. To have S-Video output. S-Video signal needs
to be input to input 1 or input 2.
(_) Audio to HI-FI
These jacks provide variable audio output to a separate stereo amplifier. With this connection, the audio to the stereo can be
controlled by the television's main volume.
(_ S-Video Inputs 1 and 2
Inputs 1 and 2 provides S-Video (Super Video) jacks for connecting equipment with S-Video output capability.
(_) Component: Y-GBC R Input 2
Input 2 provides Y-CaC R jacks for connecting equipment with this capability, such as a DVD player.
NOTE:
DO NOT connect standard VIDEO or S-VIDEO to Input 2 when using Y-CBC R input.
When using the Y-CBC R input jacks, connect your components audio output to the TV's Input 2 Left and Right Audio input jacks.
Your component outputs may be labeled Y, B-Y, and R-Y. In this case, connect the components B-Y output to the TV's C B input and
the components R-Y output to the TV's C R input.
It may be necessary to adjust TINT or turn AUTO COLOR-ON to obtain optimum picture quality when using the Y-CBC R inputs. (See
pages 47 and 48)
To ensure no copyright infringement, the MONITOR OUT output will be abnormal, when using the Y-CBC R jacks.
When using the Y-CBCR jacks, Input 2 will be viewed as a blank PIP sub-picture. (See page 22.)
(_) Speaker Matrix Surround Switch
Use this switch to choose between the surround and external speaker features. See Page 17 for Audio System Setup.
The TV's Internal Speakers will be switched off when =EXT." is selected.
(_ Rear Speaker Terminals
These terminals are used to connect external speakers, which are used for the surround sound feature, The volume level is
controlled by the remote control main volume buttons. Use speakers with 8 Ohm impedance only.
10