Table of Contents
Advertisement
.
To switch on your grass trimmer, press the
.
ON/OFF switch (B1/Pos. 2).
.
Do not move the grass trimmer against the grass
until the switch is pressed, i.e. wait until the
trimmer is running.
.
For the correct cutting action, swing the grass
trimmer to the side as you walk forward, holding
it at an angle of approx. 30° as you do so (see
B16-B17).
.
Make several passes to cut long grass shorter
step by step from the top (see B18).
.
Use the guard hood to prevent unnecessary
wear.
.
To avoid unnecessary wear, keep the grass
trimmer away from hard objects.
Using the grass trimmer as an edge trimmer
The grass trimmer can be adjusted as follows to
trim the edge of lawns and beds.
.
The grass trimmer can thus be adjusted for use
as an edge trimmer for making vertical cuts on
the grass (B15).
6. Technical data
Speed n
:
0
Battery type:
Cutting range:
Max. running period:
Sound power level L
Sound pressure level L
Replaceable NC battery:
Vibration
2
a
: 2,147 m/s
hw
2
k =1,5 m/s
9000 min
26 cm diameter
:
87.7 dB(A)
WA
:
75.3 dB(A)
pA
18 V d.c./1300 mAh
Weight:
Power supply unit:
Mains voltage:
Output:
Rated voltage:
Rated current:
The noise level of this machine may exceed 94
dB(A). In this case, noise protection is necessary
for the user. The machine's noise was measured in
accordance with prEN ISO 10518.
7. Cleaning, maintenance and ordering
of spare parts
Before putting away or cleaning the grass
trimmer, pull out the battery pack (B12 and B13).
7.1 Cleaning
.
Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it
with compressed air at low pressure.
.
We recommend that you clean the device
.
Clean the equipment regularly with a moist
cloth and some soft soap. Do not use cleaning
agents or solvents; these could attack the plastic
parts of the equipment. Ensure that no water can
seep into the device.
-1
.
Remove deposits from the guard hood with a
Li-Ion
brush.
30 min
7.2 Replacing the blade (B8,B9)
IMPORTANT! Make sure that you remove the
battery pack before replacing the blade.
.
To remove the blade, push the blade inwards
2,2 kg
210-240 V ~/ 50-60 Hz
18 V DC
1500 mA
9
Advertisement
Table of Contents
