Table of Contents
Advertisement
50-60 Hz socket.
The green LED will be permanently lit.
- Push the battery pack onto the battery charger.
The red LED will come on to indicate that
the battery pack is being charged. When the
permanently lit. The time it takes to fully recharge
an empty battery is approximately 1 hour.
Never fully discharge the battery pack. This
will cause it to develop a defect.
5. Operation
Switching ON/OFF.
The hedge trimmer is equipped with a two-
handed safety switch. The machine works only
when the switch on the steady grip (Figure 1 /
Item 3) and pressed with one hand and the switch
on the handle (B1 / Item 4) and the safety lock-
If either switch is released, the cutters will stop
moving.
Please watch out for the cutters as they slow
down to a standstill.
Notes on working practice (B6-B9)
.
A hedge trimmer can be used to cut shrubs and
bushes as well as hedges.
.
To obtain the best cutting results, hold the
hedge trimmer so that the cutter teeth are at an
angle of approx. 15° in relation to the hedge. (B7)
.
The twin-bladed cutters rotate in opposite
directions, thus enabling cutting in both
directions (see B6).
.
It is recommended to tie a guide line of string or
the like along the hedge so that you cut the
protrude beyond the guide line. (B8)
.
Cut the sides of the hedge with curve-shaped
movements from the bottom up. (B9)
8
6. Technical data
Cutting length:
Battery type:
Tooth spacing:
Cuts/min:
Charging time:
Sound pressure level, L
pA
Sound power level, L
:
WA
Front handle vibration a
hv
Rear handle vibration a
hv
Weight:
Battery pack
Voltage:
Capacity:
Battery charger
Mains voltage:
Output voltage/current:
The declared vibration emission value is for a
standardized test were measured and compared
to a power tool can be used with another;
- The declared vibration emission value can be
used for an initial assessment of the suspension.
- The vibration emission value may change
which the tool is used;
- Try to keep the burden of vibrations as low
as possible. Examples of measures to reduce
vibration exposure are to wear gloves when using
the tool and the limitation of working hours.
Here are all the shares of the operating cycle are
considered (such as times when the switch is
runs without a load).
510 mm
Li-Ion
14 mm
1100
1 h
:
71,5 dB
91,5 dB
2
:
≤1,303 m/s
:
≤ 1,362 m/s
2,6 kg
18 V DC
1,3 Ah
100-240 V ~/ 50-60 Hz
21 V DC / 1500 mA
2
Advertisement
Table of Contents
