Table of Contents
Advertisement
7. Telescope tube
8. Safety hood
9. Pedal for angle adjustment
10. Battery charger (One battery charger for all 3
machines in the scope of delivery)
11. Battery (One battery for all 3 machines in the
scope of delivery)
12. 2 Securing screws for safety hood
13. Locking knob
14. Blade
4. Before starting
4.1 Installing the safety hood (B3-B5)
.
Secure the edge guide to the safety hood (B3).
.
Place the safety hood on the trimmer (B4) and
secure to the trimmer (B5) it using the 2 securing
screws (B2 / Item 12).
4.2 Installing the additional handle (B7)
Undo the securing screw from the handle and
then place the handle on the main handle and
secure it with the screw (B7).
4.3 Fitting the blade (B8,B9)
Place the blade (B8/Item 14) with the larger
opening over the mount (B9) and then pull tight
in the direction of the arrow. Make sure the blade
locks into place correctly as shown in Figure B9.
4.4 Height adjustment (B10)
Undo the union nut (B10/Item 5) until the grass
trimmer handle can be moved in and out freely.
Now set the required working height and secure
the handle in this position by tightening the
union nut again.
4.5 Adjusting the additional handle (B7)
Undo the securing screw on the additional handle
until it can be moved forwards and backwards
without any great resistance. Set the required
8
position and tighten the securing screw again.
4.6 Adjusting the angle of the guide handle
(B11)
Place the grass trimmer on a firm surface. Press
the pedal for adjusting the angle from above
using your foot (B11/Item 9). You can now set the
handle to the required angle. Release the pedal
and allow the handle to lock into position to
fix the angle. Three different locking angles are
possible.
4.7 Charging the battery (B13-B15)
• Press the snap fastening and remove the battery
(11).
• Place the plug of charger (10) in a 210- 240V~/
50-60 Hz socket.
The red LED will be permanently lit.
• Push the battery pack onto the battery charger.
The flashing yellow LED will come on to indicate
that the battery pack is being charged. When the
charging process is finished, the green, red and
yellow LED will be permanently lit. The time
it takes to fully recharge an empty battery is
approximately 1 hour.
• Push the battery into the machine with clean
contacts until it engages.
Recharging
• Regular recharging after lengthy use and after
lengthy periods of inaction will extend the service
life of the battery.
5. Operation
Your grass trimmer will work at its best if you
observe the following instructions:
.
Never use the grass trimmer without its safety
devices.
.
Do not cut grass when it is wet. The best results
are had on dry grass.
Advertisement
Table of Contents
