Hitachi 51S700 Operating Manual page 23

HOW TO USE THE REMOTE TO CONTROL YOUR TV
CD, AMP buttons
When pressed, each of these buttons will blink to indicate the remote is in Audio mode (see page 39).
CHANNEL selector buttons
CHANNEL selector buttons are used to select channels, lock access code, etc.
Enter one, two, or three numbers to select channels. Enter "0" first for channels 1 to 9, or simply press the single digit channel you
wish to tune then wait a few seconds for the TV to tune. For channels 100 and above, press the "1" button, wait until two dashes
appear next to the channel display on your TV, then enter the remaining two numbers using the number buttons.
Channel selection may also be performed by pressing CH up ( ) or down ( ).
When in ANT C, digital channels are indicated by the use of a (-) DASH in the subchannel number (for example "15-1"). Press
buttons [0], [1], [5], [1] to tune to subchannel 15-1 or buttons [0], [1], [5], [0], [0], [1].
NOTE: The TV may not receive some channels if you are not in the correct ANTENNA/CABLE mode (see page 51).
SLEEP and (-) DASH button
Press this button to display the sleep timer in the lower left corner of the screen. Every subsequent press of this button will add 15
minutes to this timer, up to a maximum of three hours. Once set, use INFO when you want to view time remaining. If the SLEEP
button is pressed while the timer is set, it will reset to the original condition.
When in ANT C, Digital channels are indicated by the use of a (-) DASH in the subchannel number (for example "15-1"). Press
buttons [1], [5], [-], [1] to tune to subchannel 15-1.
INFO button
Press this button when you want to check the channel being received, the picture source, if the channel has stereo (ST) or second
audio program (SAP), the time, CHANNEL ID and if the TIMER is set.
Day/Night
Day
Mode
Closed
Off
Captioning
CC
Program Name
Barney & Friends
and Information Who's Who at the Zoo
Barney and the chi... 4:00PM
Day/Night
Day
Mode
Closed
Captioning Off
CC
Wide Mode
NOTES: 1. When an IEEE1394 device is connected, press CH
2. When in ANT C or a 1394 device, press the INFO button twice (2x) to see detailed program information when
available.
ANT A/ANT B
3:32 PM
Ant A 22
Stereo
R
1080i Format
4:3 Expanded HD 1080i
0:00 AM -:--
View
Zzzz
Virtual HD
Off Timer
ANT C
Main Picture
Source
9:14AM
Ant C 15-2
KPBS-DT
5:00PM
480i Engl TV-Y CC
4:3 Expanded HD 1080i
0:00 AM -:--
View
Zzzz
Virtual HD
Off Timer
Time
Main Picture Source
Audio Broadcast
Broadcast Rating
Signal Format
Wide
Mode
Sleep Timer
TV Time
Channel ID
No Information
Program Time
Digital Closed Caption
Broadcast Rating
Program Language
Digital Input Signal
Sleep Timer
, CH buttons to change Multi Channel programs.
23
3:32 PM
When an S-VIDEO
S-IN: 3
Input is connected to
VID 3
VIDEO: 3.
3:32 PM When a
YPBPR: 1
COMPONENT
VID: 1
VIDEO: Y-P B P R Input
is connected to
VIDEO: 1.
IEEE1394
When an IEEE1394 device
is connected
9:14AM
IEEE1394 01/04
Multi
PBS 1 DT
Channel
-:--AM -:--AM
Programs
Multi CC