Mercedes-Benz CLS Operator's Manual page 215

The brightness of the indicator/warning
lamps is adjusted automatically according to
the ambient light.
Visual and acoustic collision warning
If you switch on the turn signals to change
lanes and a vehicle is detected in the side
monitoring range, you receive a visual and
acoustic collision warning. You then hear a
double warning tone and red warning
lamp : flashes. If the turn signal remains on,
detected vehicles are indicated by the
flashing of red warning lamp :. There are no
further warning tones.
Course-correcting brake application
G
WARNING
A course-correcting brake application cannot
always prevent a collision. There is a risk of
an accident.
Always steer, brake or accelerate yourself,
especially if Active Blind Spot Assist warns
you or makes a course-correcting brake
application. Always maintain a safe distance
at the sides.
If Active Blind Spot Assist detects a risk of a
lateral collision in the monitoring range, a
Driving systems
course-correcting brake application is carried
out. This is meant to assist you in avoiding a
collision.
If a course-correcting brake application
occurs, red warning lamp : flashes in the
exterior mirror and a dual warning tone
sounds. In addition, the display shown in the
lower image appears in the multifunction
display.
In very rare cases, the system may make an
inappropriate brake application. An
inappropriate course-correcting brake
application may be interrupted at any time if
you steer slightly in the opposite direction or
accelerate, for example.
The course-correcting brake application is
available in the speed range between
20 mph (30 km/h) and 120 mph (200 km/h).
Either no braking application, or a course-
correcting brake application adapted to the
driving situation occurs if:
there are vehicles or obstacles, e.g. crash
R
barriers, located on both sides of your
vehicle.
a vehicle approaches you too closely at the
R
side.
you have adopted a sporty driving style with
R
high cornering speeds.
you clearly brake or accelerate.
R
a driving safety system intervenes, e.g.
R
® ®
ESP or PRE-SAFE
®
ESP is switched off.
R
a loss of tire pressure or a defective tire is
R
detected.
Switching on Active Blind Spot Assist
Make sure that the radar sensor system
X
( page 232) and Active Blind Spot Assist
Y
( page 228) are activated in the on-board
Y
computer.
Turn the SmartKey to position 2 in the
X
ignition lock.
Warning lamps : in the exterior mirrors
light up red for approximately
1.5 seconds and then turn yellow.
Brake.
Z
213