Mercedes-Benz CLS Operator's Manual page 129

Depending on the equipment level of your
vehicle, there are two variants of wiper blade;
these are installed and removed in different
ways. Based on the diagrams, check which
system is installed in your vehicle.
Changing the wiper blades (version 1)
Removing the wiper blades
Remove the SmartKey from the ignition
X
lock or turn it to position 0 (KEYLESS-GO).
Fold the wiper arm away from the
X
windshield until it engages.
Set the wiper blade at right angles to the
X
wiper arm.
Remove the wiper blade from the retaining
X
pin on the wiper arm in the direction of the
arrow.
Installing the wiper blades
Push the new wiper blade onto the
X
retaining pin on the wiper arm in the
opposite direction to the arrow.
Make sure that the wiper blade slides fully
onto the retaining pin on the wiper arm.
Turn the wiper blade parallel to the wiper
X
arm.
Fold the wiper arm back onto the
X
windshield.
Windshield wipers
Changing the wiper blades (version 2)
Removing the wiper blades
Remove the SmartKey from the ignition
X
lock or turn it to position 0 (KEYLESS-GO).
Fold the wiper arm away from the
X
windshield until it engages.
Firmly press release knob : and pull the
X
wiper blade upwards from the wiper arm in
the direction of the arrow.
Installing the wiper blades
Position the new wiper blade in the retainer
X
on the wiper arm and slide it into place in
the opposite direction from the arrow.
The wiper blade audibly engages.
Make sure that wiper blade is seated
X
correctly.
Fold the wiper arm back onto the
X
windshield.
127
Z