Active Light Function - Mercedes-Benz SLK Operator's Manual

Exterior lighting
110
when the low-beam headlamps are switched
on.
Active:
if you are driving at speeds below
R
25mph (40 km/h) and switch on the turn
signal or turn the steering wheel.
if you are driving at speeds between
R
25mph (40 km/h) and45mph (70 km/h)
and turn the steering wheel
Not active: if you are driving at speeds above
25 mph (40 km/h) or switch off the turn
signals or turn the steering wheel to the
straight-ahead position.
The cornering light function may remain lit for
a short time, but is automatically switched off
after no more than three minutes.

Active light function

The active light function is a system that
moves the headlamps according to the
steering movements of the front wheels. In
this way, relevant areas remain illuminated
while driving. This allows you to recognize
pedestrians, cyclists and animals.
Active: when the lights are switched on.
Adaptive Highbeam Assist
Important safety notes
G
WARNING
The Adaptive Highbeam Assist is only an aid
intended to support you while driving. The
driver is and remains responsible for proper
vehicle lighting in accordance with the
prevailing light, sight and traffic conditions.
The system may be impaired or unavailable
when
visibility is poor, e.g. due to snow, rain, fog,
R
or heavy spray
the optical sensor area of the windshield is
R
dirty, fogged up, or covered by a sticker for
example
The system cannot recognize the following
road users:
Road users without a lighting system of
R
their own, e.g. pedestrians
Road users with dim lighting of their own,
R
e.g. cyclists
Road users whose lighting is obstructed,
R
e.g. road users behind a guardrail
In some seldom cases, even road users with
R
a lighting system of their own may be
recognized too late or not at all.
The automatic high-beam headlamps will then
not be deactivated or it will be activated in
spite of preceding or oncoming road users.
This could endanger you and/or others and
cause an accident. Always pay close attention
to the traffic situation and switch off the high
beam manually if necessary.