Active Light Function - Mercedes-Benz SLC Operator's Manual

To switch on the high-beam headlamps:
X
turn the light switch to L or Ã.
Press the combination switch beyond the
X
pressure point in the direction of arrow :.
In the à position, the high-beam head-
lamps are only switched on when it is dark and
the engine is running.
The blue K indicator lamp in the instru-
ment cluster lights up when the high-beam
headlamps are switched on.
To switch off the high-beam headlamps:
X
move the combination switch back to its nor-
mal position.
The blue K indicator lamp in the instru-
ment cluster goes out.
Hazard warning lamps
To switch on the hazard warning lamps:
X
press button :.
All turn signals flash. If you now switch on a
turn signal using the combination switch, only
the turn signal lamp on the corresponding
side of the vehicle will flash.
To switch off the hazard warning lamps:
X
press button :.
The hazard warning lamps automatically switch
on if:
an air bag is deployed or
R
the vehicle decelerates rapidly from a speed
R
of above 45 mph (70 km/h) and comes to a
standstill
The hazard warning lamps switch off automati-
cally if the vehicle reaches a speed of above
6 mph (10 km/h) again after a full brake appli-
cation.
i
The hazard warning lamps still operate if the
ignition is switched off.
Cornering light function
The cornering light function improves the illu-
mination of the road over a wide angle in the
direction you are turning, enabling better visi-
bility in tight bends, for example. The cornering
light function can only be activated when the
low-beam headlamps are switched on.
Active:
if you are driving at speeds below 25 mph
R
(40 km/h) and switch on the turn signal or
turn the steering wheel
if you are driving at speeds between 25 mph
R
(40 km/h) and 45 mph (70 km/h) and turn
the steering wheel
The cornering lamp may remain lit for a short
time, but is automatically switched off after no
more than three minutes.
Cornering light function with traffic circle
function:
The cornering light function is activated on both
sides before entering a traffic circle through an
evaluation of the current GPS position of the
vehicle. It remains active until after the vehicle
has left the traffic circle. In this way, pedestrians
crossing the road, for example, are illuminated
by your vehicle in good time.

Active light function

The active light function is a system that moves
the headlamps according to the steering move-
ments of the front wheels. In this way, relevant
areas remain illuminated while driving. This
allows you to identify pedestrians, cyclists and
animals.
Active: when the lights are switched on.
Vehicles with Lane Keeping Assist: the active
light function evaluates the course of the lane in
which you are driving and pre-emptively con-
trols the active light function.
Adaptive Highbeam Assist
General notes
You can use this function to set the headlamps
to change between low beam and high beam
automatically. The system recognizes vehicles
with their lights on, either approaching from the
opposite direction or traveling in front of your
Exterior lighting
Z
95