Releasing - Mercedes-Benz E-Class Coupe Operator's Manual

Occupant safety
60
If you press seat-belt extender button A
after this, seat-belt extender : will not
extend.
Seat belt (example: Coupe)
Adjust the seat and move the backrest to
X
an almost vertical position (
Pull the seat belt smoothly out of seat-belt
X
extender :.
Without twisting it, guide the shoulder
X
section of the seat belt across the middle
of your shoulder and the lap section across
your pelvis.
Engage belt tongue ; in buckle =.
X
Seat-belt adjustment: if necessary, the
driver's and front-passenger seat belts
automatically adjust to the upper body
( page 60).
Y
If necessary, pull upwards on the shoulder
X
section of the seat belt to tighten the belt
across your body.
Information on releasing the seat belt with
release button ?(
Seat belt adjustment
The seat-belt adjustment function adjusts the
driver's and front-passenger seat belt to the
upper body of the occupants.
page 116).
Y
page 60).
Y
The belt strap is tightened slightly when:
you engage the belt tongue in the belt
R
buckle and you then turn the SmartKey to
position 2 in the ignition lock.
the SmartKey is in position 2 in the ignition
R
lock and you then engage the belt tongue
in the buckle once the seat-belt extender
has retracted.
The seat-belt adjustment will apply a
retraction force if any slack is detected
between the occupant and the seat belt. Do
not hold on to the seat belt tightly while it is
adjusting. You can switch the seat-belt
adjustment on and off in the on-board
computer ( page 246).
Y
The seat-belt adjustment is an integral part of
®
the PRE-SAFE convenience function. More
information about PRE-SAFE
®
under "PRE-SAFE (preventative occupant
protection)" ( page 56).
Y
Releasing seat belts
! Make sure that the seat belt is fully rolled
up. Otherwise, the seat belt or belt tongue
will be trapped in the door or in the seat
mechanism. This could damage the door,
the door trim panel and the seat belt.
Damaged seat belts can no longer fulfill
their protective function and must be
replaced. Visit a qualified specialist
workshop.
®
can be found