Roller Sunblinds; Panorama Roof With Power Tilt Sliding Panel; Opening/Closing - Mercedes-Benz E-Class Coupe Operator's Manual

Sliding sunroof (Coupe)
112
To open and close: turn the SmartKey to
X
position 1 or 2 in the ignition lock.
Press or pull the 3 switch in the
X
corresponding direction.
i
If you press the 3 switch beyond the
point of resistance, an automatic opening/
closing process is started in the
corresponding direction. You can stop
automatic operation by operating the
switch again.
Operating the roller sunblind for the
panorama roof with power tilt/sliding
panel
Important safety notes
G
WARNING
When opening or closing the roller sunblind,
parts of the body could be trapped between
the roller sunblind and the frame or sliding
sunroof. There is a risk of injury.
When opening or closing make sure that no
parts of the body are in the sweep of the roller
sunblind.
If somebody becomes trapped:
release the switch immediately, or
R
during automatic operation, push the
R
switch briefly in any direction
The opening or closing procedure will be
stopped.
The roller sunblind shields the vehicle interior
from sunlight. The roller sunblind can only be
opened and closed when the panorama roof
with power tilt/sliding panel is closed.
Roller sunblind reversing feature
The roller sunblind is equipped with an
automatic reversing feature. If a solid object
blocks or restricts the roller sunblind during
the closing process, the roller sunblind opens
again automatically. The automatic reversing
feature is only an aid and is not a substitute
for your attentiveness to the roller sunblind
while it is closing.
G WARNING
The reversing feature especially does not
react to soft, light and thin objects such as
small fingers. This means that the reversing
feature cannot prevent someone being
trapped in these situations. There is a risk of
injury.
When closing make sure that no parts of the
body are in the sweep of the roller sunblind.
If somebody becomes trapped:
release the switch immediately, or
R
during automatic operation, push the
R
switch briefly in any direction
The closing process is stopped.
Opening and closing
Overhead control panel
Opening
:
Opening
;
Closing
=
Turn the SmartKey to position 1 or 2 in the
X
ignition lock.
Press or pull the 3 switch in the
X
corresponding direction.
i
If you press or pull the 3 switch
beyond the point of resistance, an
automatic opening/closing process is
started in the corresponding direction. You
can stop automatic operation by pressing
or pulling again.