Table of Contents
Advertisement
Chapter 3
VLAN Bridge Entry
Enabled
Select Enabled to enable the mapping rule.
VLAN ID
Enter the VLAN you want to map. The default
is 2.
MAC Address
Enter the packet's source MAC address, if
applicable as a filter condition.
802.1p
Enter the priority level for each port. These are
the mappings to 802.1p:
6 High (highest, EF)
•
5 Medium (CS)
•
4 Normal (CS)
•
0 Low (best effort)
•
-1 No Change (no change to the original 802.1p
•
value)
Linksys recommends the following:
For voice and video traffic, enter
•
For gaming or mission-critical traffic, enter
•
4.
For normal traffic, enter
•
For low-priority traffic, enter
•
LAN Ports
Every LAN interface is listed, including
the Ethernet ports and Wireless Local Area Network
(WLAN) ports. (The WLAN ports are listed with their
wireless network names, also known as SSIDs.) Select the
appropriate LAN interface. For multiple selection, press
the Ctrl or Shift key. To deselect, use Ctrl + click (click the
selection).
Ethernet Frame
The Ethernet frame types are listed.
Select the packet's Ethernet frame type, if applicable as
a filter condition. For multiple selection, press the Ctrl or
Shift key. To deselect, use Ctrl + click (click the selection).
Click Add VLAN Bridge to create a new PVC/VLAN
mapping, or click Cancel Changes to cancel your
changes.
Wireless > Basic Settings
The basic settings for wireless networking are set on this
screen.
Wireless-G ADSL2+ Gateway with VoIP
6.
5.
0.
Advanced Configuration
Wireless > Basic Settings
There are two ways to configure the Gateway's wireless
settings, manual and Wi-Fi Protected Setup. For manual
configuration, use this screen to change the settings.
Wi-Fi Protected Setup is a feature that makes it easy to set
up your wireless network. If you have devices that support
Wi-Fi Protected Setup, then click the Wi-Fi Protected
Setup tab, and follow the on-screen instructions (refer
to the "Wireless > Wi-Fi Protected Setup" section for more
information).
NOTE:
Wi-Fi Protected Setup can only be used
for the default wireless network. (The Gateway
supports up to four wireless networks. The other
three can be configured using the Gateway's
web-based utility.)
Wireless Network
Wireless Channel
Select the channel you want to use.
All devices in your wireless network must use the same
channel in order to communicate.
Wireless Network State
Select the wireless standards
running on your network. If you have Wireless-G and
Wireless-B devices in your network, keep the default,
Mixed. If you have only Wireless-G devices, select G-Only.
If you have only Wireless-B devices, select B-Only. If you
do not have any wireless devices, select Disabled.
The Gateway supports up to four wireless networks. By
default, only the first wireless network is enabled. On the
Wireless Security and MAC Filter screens, you can configure
different security settings and MAC filtering rules for each
wireless network.
Configure the following settings for each wireless network
(SSID1-4):
Wireless Network Name (SSID)
case-sensitive and must not exceed 32 characters (use any
of the characters on the keyboard). Linksys recommends
that you change the default name of the first network,
linksys1, to a unique name of your choice.
The network name is
20
Advertisement
Table of Contents
