Hitachi 50V500 Operating Manual page 41

USING THE REMOTE TO CONTROL PVR FUNCTIONS
Operating the precoded function for your PVR (Personal Video Recorder).
This remote is designed to operate different types of PVRs. You must first program the remote to match the remote system of your PVR
(refer to page 43 for pre-codes).
1. Turn ON your PVR.
2. Aim the remote control at the front of your PVR.
3. Press and release the PVR button to switch to PVR pre-coded mode.
4. Hold down the PVR button on the remote and enter the two digit preset code that matches your PVR, as shown on page 43. The
indicator light will flash 3 times if the code was accepted.
5. Aim the remote at the PVR and press the POWER button. The remote will turn off your PVR when the correct two digit preset code
is entered. When this occurs, the remote control is programmed for your PVR. If the PVR does not turn off, try a different two digit
preset code.
6. The remote will now control your PVR.
NOTES:
1. If your PVR cannot be operated after performing the
above procedures, your PVR's code has not been
precoded into the remote.
2. In the unlikely event that your PVR cannot be operated
after performing the above procedures, please consult
your PVR operating guide.
3. The remote control will remember the codes you have
programmed until the batteries are removed from the
remote control. After replacing the batteries repeat the
entire programming procedure as stated above.
PVR Button
This button allows the remote to control your PVR by setting
it to PVR mode.
PRECODED PVR Buttons
These buttons transmit the chosen precoded PVR codes.
NOTE: The C.C. button functions as "replay".
EXCLUSIVE TV Buttons
These buttons are for operating the TV.
NOTE: Refer to instruction manual of the PVR for operation of the buttons exclusively for the PVR.
TV
DVD
SLEEP
VOL
PIP
PIP MODE
REC
MY PVR CODE IS:
41
POWER
VCR CBL
STB
SOURCE WIZARD
CD
PVR
AMP
1
2 3
4 5 6
7
8 9
0
INFO
A/V NET
SELECT
CH
VID3
SURF FREEZE
PIP ACCESS
SWAP
DAY/NIGHT
CLU-5729TSI