Using The Remote To Control Vcr Functions; Precoded Vcr Buttons; Exclusive Tv Buttons - Hitachi 50V500 Operating Manual

USING THE REMOTE TO CONTROL VCR FUNCTIONS

Operating the precoded function for your VCR.
This remote is designed to operate different types of VCRs. You must first program the remote to match the remote system of your VCR
(refer to page 43 for pre-codes).
1. Turn ON your VCR.
2. Aim the remote control at the front of your VCR.
3. Press and release the VCR button to switch to VCR pre-coded mode.
4. Hold down the VCR button on the remote and enter the two digit preset code that matches your VCR, as shown on page 43. The
indicator light will flash 3 times if the code was accepted.
5. Aim the remote at the VCR and press the POWER button. The remote will turn off your VCR when the correct two digit preset code
is entered. When this occurs, the remote control is programmed for your VCR. If the VCR does not turn off, try a different two digit
preset code.
6. The remote will now control your VCR.
NOTES:
1. If your VCR cannot be operated after performing the
above procedures, your VCR's code has not been
precoded into the remote.
2. In the unlikely event that your VCR cannot be operated
after performing the above procedures, please consult
your VCR operating guide.
3. The remote control will remember the codes you have
programmed until the batteries are removed from the
remote control. After replacing the batteries repeat the
entire programming procedure as stated above.
4. The MENU button will act as the VCR MENU button for
HITACHI VCRs.
5. The LAST CH button will act as your VCR ENTER button
if required.
6. The SLEEP button will act as your VCR '100' button if
required.
VCR Button
This button allows the remote to control your VCR by set-
ting it to VCR mode.

PRECODED VCR Buttons

These buttons transmit the chosen precoded VCR codes.
For some VCRs, you must press the RECORD button twice
to record a program.

EXCLUSIVE TV Buttons

These buttons are for operating the TV.
NOTE: Refer to instruction manual of the VCR for operation of the buttons exclusively for the VCR.
TV
DVD
1
4
7
SLEEP
VOL
PIP
PIP MODE
REC
MY VCR CODE IS:
37
POWER
VCR CBL
STB
SOURCE WIZARD
CD
PVR
AMP
2 3
5 6
8 9
0
INFO
A/V NET
SELECT
CH
VID3
SURF FREEZE
PIP ACCESS
SWAP
DAY/NIGHT
CLU-5729TSI