Important
•
Motherboard photos shown n ths secton are for demonstraton only. The appear-
ance of your motherboard may vary dependng on the model you purchase.
•
If you ntend to nstall TWO graphcs cards for CrossFreX
a. these two graphcs cards are of the same brand and specficatons;
b. these two cards are nstalled on both mazarne PCIE x16 slots.
Make sure that you connect an adequate power supply to the power connector on the
•
graphcs card to ensure stable operaton of the graphcs card.
•
Only Wndows
XP wth Servce Pack 2 (SP2)& Wndows
®
ton & Wndows
Vsta support the CrossFreX
®
3.
When all of the hardware and software has been properly set up and nstalled, re-
boot the system. After enterng the O.S., clck the "Catalyst
on the desktop. There s a settng n the Catalyst
enabled for CrossFreX
Control Center:
Select the Advanced Vew
from the vew drop menu.
Important
A CrossFreX
system has four possble dsplay modes:
TM
•
SuperTlng
•
Scssor Mode
•
Alternate Frame Renderng
Super Ant-alasng.
•
for more detals, please consult the graphcs card manual from the manufacturer.
TM
to operate. The followng aspect appears n Catalyst
TM
mode, make sure that:
TM
XP Professonal x64 Ed-
®
functon.
Control Center" con
TM
Control Center that needs to be
TM
MS-7522
MS-7522
TM
2-23