Table Of Contents - Linksys WPC11 Quick Installation Manual

COPYRIGHT & TRADEMARKS
Specifications are subject to change without notice. Copyright © 2003 Linksys, All Rights
Reserved. Instant Wireless, Linksys, and the Linksys logo are registered trademarks of
Linksys Group, Inc. Microsoft, Windows, and the Windows logo are registered
trademarks of Microsoft Corporation. All other trademarks and brand names are the
property of their respective proprietors.
SAFETY AND REGULATORY NOTICES
FCC STATEMENT
The Instant Wireless ® Wireless Network PC Card has been tested and complies with the
specifications for a Class B digital device, pursuant to Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may
cause undesired operation.
These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used according to the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which is found by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
Reorient or relocate the receiving antenna
•
• Increase the separation between the equipment or devices
• Connect the equipment to an outlet other than the receiver's
Consult a dealer or an experienced radio/TV technician for assistance
•
FCC Caution: Any change or modification to the product not expressly approved by
Linksys could void the user's authority to operate the device.
FCC RF Radiation Exposure Statement
To comply with the FCC and ANSI C95.1 RF exposure limits, the antenna(s) for this
device must comply with the following:
• Access points with 2.4 GHz or 5 GHz integrated antenna must operate with a
separation distance of at least 20 cm from all persons using the cable provided and
must not be co-located or operating in conjunction with any other antenna or
transmitter.
End-users must be provided with specific operations for satisfying RF exposure
compliance.
Note: Dual antennas used for diversity operation are not considered co-located.
WPC11-EU_V31-QIG-30131NC JL
2
Instant Wireless Series
®
Wireless Network PC Card

Table of Contents

Package Contents
Before You Begin
Step 1: Software Installation and Configuration for
Windows 98SE, Me, and 2000
Step 2: Connecting the Wireless Network PC Card
Step 3: Driver Installation and Configuration for
Windows XP
For product support and product registration, contact us at the addresses below:
E-mail
Europe
Latin America
Web
europe-support@linksys.com
latam-soporte@linksys.com
http://www.linksys.com/international
4
4
5
9
10
3