General Operating Instructions - Chicago Electric 69946 Owner's Manual

WORKPIECE AND WORK AREA SET UP
1. Designate a work area that is clean
and well-lit. The work area must not
allow access by children or pets to
prevent distraction and injury.
2. Route the power cord along a safe route
to reach the work area without creating a
tripping hazard or exposing the power cord
to possible damage. The power cord must
reach the work area with enough extra length
to allow free movement while working.

GENERAL OPERATING INSTRUCTIONS

1. Charge the Battery Pack (18) and insert it in
the tool, as described in the previous section.
2. Select an appropriate bit or attachment
for the job. Insert the bit or attachment
as described in the previous section.
3. The LED Collar may be turned on by
moving the switch on the collar.
4. Rotate the Switch (8) to the ON position.
This is a variable speed switch. The tool
bit speed is dependent on the position of
the Switch. Use a speed appropriate to
the bit and the material being worked on.
In general, harder materials require faster
speeds and softer materials require slower
speeds. Relative speeds are indicated
by the numbers on the Switch.
Page 12 For technical questions, please call 1-800-444-3353.
3. Secure loose workpieces using
a vise or clamps (not included)
to prevent movement while working.
4. There must not be objects,
such as utility lines, nearby that will
present a hazard while working.
5. Apply the tool bit to the work
material as needed.
6. When the task has been completed, stop the
tool by rotating the Switch (8) to the OFF ("O")
position. If the LED Collar is ON, switch it OFF.
Unplug the rechargeable battery.
Remove the bit or attachment as
discussed in the previous section.
7. Store the tool, its battery, and its bits and
attachments in their case in a safe location.
Item 69946