Face Shield Assembly; Components And Controls - Chicago Electric 69029 Owner's Manual

Setup
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:
Turn the Power Switch off and unplug the welder before assembly.

Face Shield Assembly

1. Attach the handle to the Face Shield by lining up
the two rectangular tabs on the handle with the
corresponding holes in the face shield and
A. press the tabs through the holes and then
B. slide the tabs forward from the back,
locking the round tab in place.
2. Wear heavy-duty work gloves, the edges of the
filter lens may be sharp. Remove any protective
film from both sides of the filter lens. Slide the
filter lens into the helmet behind the holding tabs.
Make sure that the filter lens fits securely and
that light cannot leak around its edges.

Components and Controls

Power
Light
Power
Switch
SKU 69029
Electrode Holder
For technical questions, please call 1-800-444-3353.
B B
A A
Face Shield
(viewed from front)
(viewed from back)
Current
Indicator
Overload
Light
Grounding Clamp
Round
Tab
Handle
Filter Lens
Face Shield
Current
Knob
Page 7