Preset For Use; Automatic Channel Preset (Without A Cable Box) - Hitachi VT-MX211A Owner's Manual

PRESET FOR USE

PRESET FOR USE
Channel memory programming is NOT needed when connected to a cable box. You
can program the tuner to scan only the channels you receive in your area. See page 29
for channel designations.
NOTE: You must use the remote control for this procedure.

AUTOMATIC CHANNEL PRESET (Without a Cable Box)

NOTES:
• Follow the steps below once. Repeat it only if there is a power failure or the VCR is
unplugged for more than 30 seconds. (In these cases, the programmed channels are
erased.)
• You must follow the steps below before attempting to play or record a video tape. If you
want to play or record a video tape. If you want to play or record a video tape BEFORE
programming the tuner, you must first press the POWER button to turn off the VCR. Then,
press the POWER button again to turn it back on. To program the tuner again, see
"CHANNEL PRESET AGAIN".
1 Plug in the VCR power cord ("--:--" flashes)
Plug the VCR power cord into a standard AC outlet.
2 Select channel 3 or 4 on the TV
Turn on the TV and set the TV channel to the same video output channel as located on
the back of the VCR. (CH3 or 4)
3 Turn on the VCR
Press the POWER button to turn on the VCR. " " appears on the display.
19