Attach The Tv And Vcr To The Power Supply; Install Batteries In The Remote Control; Set The Rf Or Video Channel Switch - Hitachi VT-F390A Owner's Manual

connector to the IN FROM ANT jack on the back of the VCR.
2. Using the 75 ohm cable supplied with your VCR, connect either end to the
OUT TO TV jack on the back of the VCR.
3. Use a second adapter to attach the other end of the 75 ohm connector
back into the TV (where you first disconnected the antenna).
Capabilities: With this hookup, you should now be able to perform all basic
functions provided by this equipment.

5 Attach the TV and VCR to the Power Supply

Plug in the TV and VCR power cords to the wall outlet or an appropriate
extension cord or surge protector. See Important Safeguards for further
precautions (page 6).

6 Install Batteries in the Remote Control

The remote control requires two fresh "AA" batteries. On the back of the
remote, a plastic cover slides off in the direction shown by the arrow.
Remove this cover and install the batteries, matching the plus end of each
battery with the plus mark on the remote.

7 Set the RF or Video Channel Switch

When the VCR is on, its video signal can come into your TV on either
channel 3 or channel 4. You need to select the appropriate channel.
Turn the power on to both the TV and the VCR, and look for a switch on
the back of the VCR. Set the switch to 3 or 4, whichever is not a commercial