Table of Contents
Advertisement
Notice
•
When mounting a projector other than a SANYO
model onto the projector bracket, mount it with the
adjustment feet on the bottom of the projector
retracted.
•
Follow the steps below to mount a SANYO model.
1
Extend the two adjustment feet by pulling them
out.
2
Pass the adjustment feet through hole A in the
projector bracket.
3
Move the projector bracket, move the adjustment
feet of the projector to the positions shown in the
figure below, then align the positions of the
spacers with the holes for fastening the projector,
and use the screws to fasten the projector.
Adjustment Feet
Screw Fastening Positions
4
Retract the adjustment feet.
1
Secure the spacers (A) and bushings (B) used
to secure the projector through the holes to be
used for the projector model concerned on the
projector bracket in such a way that the
bracket is sandwiched between the spacers
and bushings.
•
The spacers (A) used to secure the projector
are secured in the holes whose positions are
indicated by the initial of the projector brand.
Initial
"P"
"S"
"E"
"O"
"A"
"B"
Hole A
Bushing for Securing
Projector (B)
Spacer for Securing
Projector (A)
2
Align the attached spacers with the holes used
to suspend the bottom panel of the projector,
and secure them using the screws (C)* for
securing the projector.
Screw for Securing
Projector (C)*
Bushing for Securing
Projector (B)
Spacer for Securing
Projector (A)
* For an Acer projector, use the screws (I) for
securing the projector (for Acer) instead.
Wall Mounting Construction
Projector model name
Panasonic
PT-ST10
SANYO
LP-WXL46(S)
EPSON
EB-410W
Optoma
EX525ST
Acer
S1200
MP772ST
BenQ
MP776ST
MP782ST
Installation Manual
No. of
spacers
3
5
5
4
3
3
25
Advertisement
Table of Contents
