Download Print this page
Panasonic ET-RFD32 Installation Manual
Panasonic ET-RFD32 Installation Manual

Panasonic ET-RFD32 Installation Manual

Frame for panasonic pt-rz31k; panasonic pt-rs30k; panasonic pt-rq32k

Advertisement

INSTALLATION MANUAL
ET-RFD32
For projectors:
PT-RZ31K / PT-RS30K / PT-RQ32K
Only a quali ed installer should install this product.
Read these instructions carefully before installing the ET-RFD32 projector frame.
These installation instructions must always be handed over to the installing person.
2
3
4
4
5
5
6
7

Advertisement

loading

Summary of Contents for Panasonic ET-RFD32

  • Page 1: Table Of Contents

    & weight Dimensions For projectors: PT-RZ31K / PT-RS30K / PT-RQ32K Only a quali ed installer should install this product. Read these instructions carefully before installing the ET-RFD32 projector frame. These installation instructions must always be handed over to the installing person.
  • Page 2: Important Safety Notice

    IMPORTANT SAFETY NOTICE Dear customer, Thank you for choosing the ET-RFD32 frame for Panasonic DLP® based projectors. This instruction booklet provides you with all the necessary operating information that you may require. It will help you to get the best performance out of this new product. We hope you will be pleased with your Panasonic projector frame.
  • Page 3: Product Description

    PRODUCT DESCRIPTION Part name Image/Drawing Purpose Finished assembly diagram Frame Used for projector installation. Another separate Screws (M10x35) x 6 Screws and Used for securing the frame is required washers projector into the frame. for tandem assemblies. Flat washers (M10) x 12 max.
  • Page 4: Assembly Procedure

    INSTALLING THE PROJECTOR IN THE FRAME Before installing of the frame, remove the handles on the front and the back of the projector. screw (M10x35) Place the frame on the projector so that it is aligned with the screw hole positions. (Make sure that the forward/back direction is correct when installing.
  • Page 5: Installing Tandem Projections

    Make sure the four male location bolts enter into the correspondent female location bolts. To secure, draw the locking pin through both bolts. MAXIMUM STACKING INFORMATION Frame ET-RFD32 ceiling mount with TH-SHORTY-350-8/10 table mount...
  • Page 6: Adjustment Options

    ADJUSTMENT OPTIONS Using the adjusting screws to the left and right you can adjust the position of the projector by approximately three degrees. You can lower or lift the front left or right corner. adjusting screws By turning the single round adjustment screw, placed on the side of the frame, you can move the back of the projector to the left or to the right by approximately...
  • Page 7: Dimensions & Weight

    DIMENSIONS & WEIGHT Weight: 37,10kg          ...
  • Page 8 Made in Germany by Sager Metallbearbeitung www.lang-ag.com 03/17...