Fujitsu SPARC Enterprise M4000 Reference Manual page 422

testsb(8)
OPTIONS
OPERANDS
EXTENDED
DESCRIPTION
496
The following options are supported:.
-c {all|expansion} Specifies the target PSB to be diagnosed. One of the values
-h
-m diag=mode
-n
-q
-v
-y
The following operand is supported:
location Specifies only one PSB number. An integer from 00–15 can be
specified.
When the system board (XSB: eXtended System Board) belonging to the specified
■
PSB is in any status below, the testsb(8) command results in an error.
XSB is installed in the domain and this domain is in operation.
■
XSB is installed in the domain and this domain is in OpenBoot PROM (ok>
■
prompt) status.
XSCF Reference Manual • Last Revised January 2007
shown below can be specified:
Diagnoses all the PSB that are mounted.
all
If the following conditions not satisfied, it leads to an
error.
The system has been powered off.
■
All of the target PSB are Uni-XSB.
■
Diagnoses all the PSB that are mounted
expansion
on the expansion cabinet.
If the following conditions not satisfied, it leads to an
error.
All of the target PSB are not operating on the domain.
■
All of the target PSB are Uni-XSB.
■
Displays usage statement. When used with other options or
operands, an error occurs.
Specifies the diagnostic level of initial diagnosis. One of the
values shown below can be specified:
Normal (default)
min
Maximum
max
Automatically answers 'n' (no) to all prompts.
Suppresses all messages to stdout, including prompts.
Displays a detailed message of initial diagnosis.
Automatically answers 'y' (yes) to all prompts.