Data Backup; Maintenance Support Period - Fujitsu Eternus DX60 Setup Manual

Setting up the ETERNUS DX60/DX80 to Support Maintenance
S T E P
Various settings are needed to make certain post-operation maintenance tasks easier.
Notification of ETERNUS DX60/DX80 problems as they occur is possible if the event notification method and level have
been set.
For e-mail notification of ETERNUS DX60/DX80 problems, a destination e-mail address must be set.
If the ETERNUS DX60/DX80 is to be connected to a PRIMERGY and "ServerView" used to monitor the server, the
ETERNUS DX60/DX80 needs to be set to send SNMP traps to the server.
If remote support is required, the ETERNUS DX60/DX80 needs to be set to notify the remote support center of failures.
"4.4 Maintenance Setup" in the "User Guide"
Point
Server Connection
S T E P
Various tasks need to be performed before the ETERNUS DX60/DX80 can be connected to the server. These include the
installation of the appropriate drivers and the setup of Fibre Channel switches.
Check which server OS, Fibre Channel cards, and Fibre Channel switches are to be connected to before starting this step.
"4.5 Setting up the Server Connection" in the "User Guide"
"ETERNUS Disk storage systems Server Connection Guide (Fibre Channel)"
- for Solaris™ Operating System
- for HP-UX
- for AIX
- for Windows®
- for VMware® ESX
All necessary settings are complete, and the ETERNUS DX60/DX80 is now ready for normal operation.
Operation and Maintenance
S T E P
Maintenance after starting operation:
Status check
The status of the ETERNUS DX60/DX80 should be regularly monitored by checking the LEDs and using the Web browser.

Data backup

Important data should be regularly backed up to a tape drive or similar device as a precaution against system failures.

Maintenance support period

The maintenance support period for the ETERNUS DX60/DX80 is 5 years from the date of purchase.
This manual uses recycled paper.
Remote support allows prompt detection and resolution of trouble.
- for Linux
- ETERNUS Disk Storage System Settings for ETERNUS DX60/DX80
- Fibre Channel Switch Settings
- for Egenera BladeFrame
ETERNUS DX60/DX80 Disk storage system Setup Guide
Issuance responsibility: FUJITSU LIMITED
The contents of this manual may be updated without notice.
While the contents of this manual are the product of all due care and
diligence, no responsibility can be accepted for operational problems
arising from any errors or missing information, or other use of the
information contained in this manual.
Fujitsu assumes no liability for damages to third party copyrights or
other rights arising from the use of any information in this manual.
Contents of this manual are not to be reproduced without permission
from Fujitsu.
Manuals with missing or wrongly collated pages will be replaced free of
charge.
(Fibre Channel model)
P3AM-3082-02EN
Date of issuance: October 2009
Printed in Japan