Advertisement
Master Reset
Press
to display Are You Sure?
Then < for Yes, > for No.
Brewer factory defaults are then reset.
Service Call (Phone number Factory set to [800] 000-0000)
Press
to display number and change number or < to move place and EX to exit when complete This number will be displayed during a
Heating system SENSOR ERROR or during a WATER ERROR.
Access Code (Factory set to 1-2-3-4)
Press
to display number and change number, (the number can be change 1 to 4) or < to move place and ex to exit when complete.
Banner Name (Factory set to WILBUR CURTIS)
Press
to display letters and change letters or < to move place and EX to exit when complete
This feature allows up to 14 letters to be programmed for company name or regional name. Programming all blanks disables Banner Name. If
programmed, Banner Name is displayed every 5 sec. on and off.
P-Maintenance (Factory set to OFF)
P-Maintenance (Factory set to OFF)
P-Maintenance (Factory set to OFF)
P-Maintenance (Factory set to OFF)
P-Maintenance (Factory set to OFF)
Press
to Select, Set gallons brewed to indicate P-Maintenance. Press < or > to adjust from Off to 3000 gallons. Press
Beeper On/Off (Factory set to ON)
Press
to display ON or OFF. Pressing either < or > toggles between on and off.
Pulse Brew (Factory setting OFF)
Press
to select, < or > to select OFF or one of four pulse patterns (A to D) .
Guidelines for Pulse Brew:
This feature allows tuning of the coffee flavor. This option should only be used with the standard Gray or Purple AFS sprayheads. The pot level
should always be set first with this option OFF. Depending on your grind profile and water conditions, the three Pulse Brew options help "tune"
or change the coffee flavor. Filter Pack type coffees typically extract better with the A and B pulse setting. Decaffienated coffees typically
extract better with the B pulse setting. High-Yield coffees typically extract better with the C pulse setting. Of course, any of the A, B or C
settings may be used to suit your taste profile.
If Pulse Brew is selected (ON), Cold Brew Lock is set to Delta 1 within 5ºF of set point and Cold Brew Lock disappears from the list of
program selections.
When Pulse Brew is ON, Pre-infusion disappears from the list of program selections.
Model Select
Press
to select, < or > to select model. The selections are: ALPHA-1, ALPHA-2, ALPHA-3/4/5, Airpot Brewer, Thermo-Alpha. For the
TA60GT, select Thermo Alpha. Press
Exit
Press
to select, this selection will exit program mode and return the unit to normal operation.
Tank Temperature Check
Turn on brewer at the control panel ON/OFF button. Press and hold
will be displayed (temperature in heating tank). This feature does not function during the initial brewer warm-up.
to set. The control will reset itself when a new model is selected.
to set.
3
button (see illustration, page 2) for 5 seconds. Water Temperature
to exit.
3
Advertisement
