Hitachi L32BD304 Owner's Manual page 34

Connections to other equipment
To connect an audio system
This connection allows you to use an audio amplifier and external speakers, and adjust the audio level using the TV's remote control.
To control the audio, turn on the TV and the stereo amplifier, and turn off the TV's built-in speakers (see page 18).
Rear of the TV
NOTE:
To hear sound when using an external audio amplifier, the volume of both the TV and the amplifier must be set above 0 (zero).
For example, if the volume of the TV is set to 0, you will not be able to hear any sound, even if the volume of the amplifier is at its highest
level.
To connect the TV/BD to a camcorder, or a TV Game
To play back from a camcorder, connect the camcorder to the unit as shown.
This unit can also be used as a display device for many video games. However, due to the wide variety of signals generated by these
devices and subsequent hook-up variations required, they have not all been included in the suggested connection diagrams. You'll need
to consult each component's Owner's Manual for additional information.
Rear of the unit
To connect the TV/BD to a PC (Personal Computer)
Before you connect this TV/BD to your PC, change the adjustment of your PC's Resolution and Refresh rate (60 Hz).
Connect one end of a (male to male) VGA cable to the video card of the computer and the other end to the VGA connector PC MONITOR
IN on the rear of the TV/BD. Attach the connectors firmly with the screws on the plug. In case of a Multimedia computer, connect the audio
cable to the audio output of your Multimedia computer and to the AUDIO connector of the PC/DVI AUDIO IN jack of the TV/BD. You can
also connect the PC with HDMI cable. If you use a HDMI cable, you don't have to connect the audio cable. If you use a DVI-to-HDMI
cable, please connect the audio cable in the same way as the VGA cable.
Press INPUT on the remote control to select PC mode.
Switch on the computer. The TV/BD can operate as the computer monitor.
Rear of the unit
To PC/DVI
AUDIO IN
Audio cable
To HDMI1/
(not supplied)
DVI IN
NOTE:
• The on-screen displays will have a different appearance in PC mode than in TV mode.
• If there is no video signal from the PC when the unit is in PC mode, "No signal" will appear on the TV screen.
34
To VAR (VARIABLE)
AUDIO OUT
Audio cable (not supplied)
To LINE 1 To Video/Audio OUT
VIDEO/AUDIO IN
Video/Audio cable
(not supplied)
To PC
MONITOR IN
VGA cable
(not supplied)
HDMI cable (not supplied)
Amplifier
To Audio (L) Input
To Audio (R) Input
Monitor Display modes
MODE Resolution
VGA
VGA
SVGA
XGA
SXGA
WXGA 1280x768
WXGA 1280x720
WXGA 1360x768
WXGA+ 1440x900
FHD
To return to normal mode
Press INPUT again.
(continued)
or
Refresh rate
640x480 60/ 72/ 75 Hz
720x400 70Hz
800x600 56/ 60/ 72/ 75 Hz
1024x768 60/ 70/ 75 Hz
1280x1024 60Hz
60Hz
60Hz
60Hz
60Hz
1920x1080 60Hz