Display - Fostex HP-A8 Quick Start Manual

[ ANALOG OUT ] (LEFT, RIGHT) connectors
(RCA jack)
These connectors are used to connect to an audio
amplifier, etc.
The audio signal is output from these connectors
when the [ OUTPUT SEL ] switch on the front panel
is down.
[ ANALOG IN ] (LEFT, RIGHT) connectors
(RCA jacks)
This connector receives an analog audio signal.
It is used to connect to an analog audio playback
device or a digital audio playback device that does
not have a digital output.
The following three display modes are available.
• Normal display mode
Normally the display shows the current input
source, Fs condition and volume level position.
OPT 1
48.0K
• Menu display mode
Pressing the [ MENU ] key on the remote controller
enters the menu mode. In the menu mode, the dis-
play shows a menu item and the current setting for
that menu item.
-> AMP GAIN
10.0dB
For details about the menu mode, see "Using the
menu" on page E-11.
Features and controls
Rear panel
1 2
OPTICAL COAXIAL OPTICAL COAXIAL
DIGITAL IN DIGITAL OUT
ANALOG OUT ANALOG IN
RIGHT LEFT RIGHT
-20.0dB
USB
SD CARD
IN
LEFT
AES/EBU
To listen to the audio source of the [ ANALOG IN ]
connectors, select "ANALOG" by rotating the [ IN-
PUT SEL ] dial on the front panel.
[ AES/EBU ] input connector (XLR female)
This connector receives an AES/EBU digital audio
signal and is used for connecting to a digital audio
playback device such as a CD player.
To listen to the audio source of this connector, se-
lect "AES/EBU" by rotating the [ INPUT SEL ] dial on
the front panel.
[ AC IN ] connector
Connect the supplied power cord to this connector.

Display

• SD display mode
When "SD" is selected as the input source, the dis-
play shows something like the one below. You can
see the volume level position, playback/stop status
and current folder/file name.
SD
JAZZ/BLUES#1.dsf
AC IN
-20.0dB