How To Use - Vax W87-RP-C User Manual

IMPORTANT: Before setting the machine up to wash, ensure the clean water tank is rinsed thoroughly of
pre-treatment solution.
Operating your carpet washer
Your dirty water tank is fitted with a float. When the dirty water tank is full or the floor head is not in contact with the carpet
the float will shut off the suction at the floor nozzle. You will be able to hear if this has happened as the motor noise on the unit
will increase. Once the float is activated, empty the dirty water tank if full. If the dirty water tank is not full then turn off your
machine at the power switch and wait for the float to settle before re-starting.
Remove clean water tank.
Tighten cap before
returning tank to unit.
Press on the handle release
pedal and pull the cleaner
back into a reclined position.
vax.co.uk
Place the clean water tank
back on the carpet cleaner.
When machine is reclined
brushbar will power.
Upright position brushbar
will not power.
Pour required dose of carpet
cleaning solution (approx.
40ml per 1.0L of water.)
Unwrap power cord
and plug unit in.
Press trigger to
release solution.

How To Use

Mix the solution with warm
water (max 40 C) and fill
O
tank with solution.
Turn the power and brush
bar switches on.
For best results apply
solution on the forward
stroke and release the
trigger to recover solution
on the backward stroke.
6