Dual XGPS160 Owner's Manual page 6

the XGPS160 will automatically try to reconnect to
the last device it was paired with.
NOTE: If your device requires a code to connect
during the pairing process, use "0000" or "1234".
Pairing the XGPS160 with the iPod touch, iPad
or iPhone
(NOTE: these instructions were written using iOS
version 6.1 and may be different if you are using a
different version of the iPhone OS.)
• On the iPad/iPod touch/iPhone, go to:
and turn on Bluetooth. The iOS device will auto-
matically begin looking for the XGPS160.
• Turn on the XGPS160. The blue Bluetooth
status light on the XGPS160 will begin to blink
slowly (about once per second).
• After a few seconds, the XGPS160 will appear
as
XGPS160-xxxxxx
the touch/iPad/iPhone screen. (The last 6 digits
are part of the XGPS160 serial number and
will be different for each unit.) The word
may also appear for a few moments before
XGPS160-xxxxxx
• Tap
XGPS160-xxxxxx
connect to it. The words "Not Paired" will disap-
pear and be replaced by the spinning cursor.
6
XGPS160
Settings->Bluetooth
appears.
in the list of devices on
in the list of devices to
Misc