Display Bezel; Removing The Display Panel - Dell Inspiron 8200 Manual

1 M2.5 x 4-mm screws (6)
2 rubber screw covers (4)

3 display bezel

4 plastic tabs (6)
5 M2.5 x 4-mm screw
6 flex-cable mounting bracket
7 display latch
Display Bezel
1. Use a scribe to pry out the four rubber screw covers located across the top of the bezel.
2. Remove the four M2.5 x 4-mm screws located across the top of the bezel.
3. Use a scribe at the indentations to pry out the two plastic screw covers located at the bottom of the bezel.
4. Remove the two M2.5 x 4-mm screws located at the bottom of the bezel.
5. Separate the bezel from the top cover.
The bezel is secured to the top cover with plastic tabs around the sides. Use a plastic scribe to help separate the bezel from the top cover.
Display Panel

Removing the Display Panel

1. Remove the hinge cover.
2. Detach the display flex cable
3. Remove the display bezel.
4. Remove the M2.5 x 4-mm screw that secures the plastic flex-cable mounting bracket to the top cover.
5. Remove the six M2 x 3-mm screws (three on each side) from the right and left sides of the panel.
6. Lift the display panel and flex cable out of the top cover.
7. Disconnect the flex cable from the two connectors (one ZIF and one standard connector) on the display panel.
1 ZIF connector
2 standard connector
8 M2 x 3-mm screws (6)
9 top cover
10 hinge cover
11 display flex cable
12 display panel
13 plastic screw covers (2)
from the strain relief and the graphics card.